Tractor Talk Discussion Board |
Re: Backhoe Hydraulic Cooler Removal
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by NC Wayne on October 12, 2004 at 20:42:24 from (205.188.117.10):
In Reply to: Backhoe Hydraulic Cooler Removal posted by AndrewS on October 12, 2004 at 06:56:51:
Like one post said typically the thin nut is actually soldered to the cooler and is used to prevent twisting off the cooler leg while the wider one should swivel around the line. One secret I've found over the years that works great on hydraulic fittings is this. Now depending on how stiff the cooler legs are you might have to use something as a back up device, but take a hammer or a hammer and punch and give the swivel nut several good hard whacks on a couple of the flats. I've seen #32 fittings that wouldn't budge with a wrench and a cheater pipe break loose with the wrench alone after a couple of good solid hits. Like the old saying goes when all else fails get a bigger hammer...in this case though it actually works. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|