Tractor Talk Discussion Board |
JD 7520
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Midniterambler on January 31, 2004 at 15:15:51 from (152.163.253.66):
A while back, I bought a JD 7520.Have been using it for disk ripping, chiseling,etc. The rear main seal was leaking, so a neighbor and I split it and repaired the engine clutch while apart. Works good now. I'm wondering about the reliability of the 531c.i. vs. the problem-prone 619. Mine is stone stock, and does all I ask of it. My only complaint is the noise-seems the gear noise and vibration travel up the roll-bar supports. Kinda like sitting in a big tuning fork for hours on end. I've run many 4020s, 4320s, and 4620s and none were this loud. I'm wondering if any old plowjockeys from the 1970s have any suggestions for silence or other tips for keeping this old dinosaur running.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|