Tractor Talk Discussion Board |
Re: Re: Re: '51 8N 3pt levers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sue on May 30, 2003 at 11:05:04 from (152.163.252.71):
In Reply to: Re: Re: '51 8N 3pt levers posted by Mike Johnson on May 29, 2003 at 09:53:07:
Thanks for the info guys. Makes a bit more sense now. Still have a bit of a problem with getting the brush hog to return to a set position after raising it to avoid an obstacle. We seem to have to raise the brush hog up all the way and then move the lever a little past the stop and then up onto the stop to maintain the same position we had before. Is it possible to just raise the hog up just a little and then back to the original position without monkeying with the lever so much? After mowing a bit more, I can see where the PTO override clutch would be handy. Thanks for any addtional info. Sue
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|