Posted by warbaby on August 01, 2021 at 05:16:26 from (24.247.205.221):
In Reply to: Fprd 8n Valve Woes posted by Funford on July 31, 2021 at 19:27:41:
Yes it does. Take off the drain plug/screen and try to snake a magnet on a flexible wand around in the oil pan to retrieve it. Maybe you are lucky and it didnt fall into the front baffled compartment of the oil pan. That pan is pretty deep, and if its never been off, there are probably worse things in it lurking far below the rotating crank and rods nestled securely in the accumulated sludge. If you have another rotator cap handy, I'd just leave that one in the pan so youre always carrying a spare.
You could put a few cow magnets on the bottom of the pan to help hold it (and any other metallic bits) tight to the pan and keep them from rolling about if it bothers you.
Now, the real question is: Unless you were installing new valve & guide assemblies, how did those valve clearances get so loose that a cap could come off and have enough room to slip between the valve stem and the lifter?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.