Posted by CTX1836 on July 23, 2021 at 03:20:42 from (76.10.244.142):
Howdy folks I have ordered some new rings for the 8n as well as all new gaskets, water pump, belt, oil filter ect.. I will also be ordering the valve train kit. My main question is how do I take out the pistons to be able to replace the rings? I am brand new to this and never have worked on engines in this depth. I already have the head off as well as the rest of the components off of the engine block. I suspect that I have the separate the block from the oil pan so I can get to the crank shaft and thus the pistons. I was getting some oil blowing by one of the cylinders and I couldnt get the rings to come back around when it was running. Also the valves look like the original 1951-52 valves. They even say Ford on the top still and have a good amount of carbon on a few of them. I can break the tractor in half if I need to. I heard that this would make the engine rebuild way easier and prob make painting a heck of a lot easier as well once its rebuilt. Anyway I know this is long winded but I appreciate your time and help. Thank you in advance.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.