Posted by super99 on May 06, 2021 at 10:20:25 from (184.20.245.17):
I'm ready to pull what hair I have left out!!! Here is what I checked this morning. #1 I found the manual for my multi meter so I was using it correctly. I checked ohm reading on the fuel guage.
It said 157, I checked the old guage and the reading was 117. I clamped the sending unit in the vise and tested it, the numbers changed as I moved the float arm, so the sending unit should be good. The slip on connector on the sending unit wasn't a good fit, so I bent the tangs down a bit so it fits tight on the spade. I connected the wires to the sending unit outside the tank and moved the float arm, nothing. I took both the power and ground wires off and checked them with a test light hooked to a good power source and ground and both wires are good.
I grounded the wire from the guage and the needle moved to full from empty. When I put the sending unit in the tank, hook up the wires, turn on the key for power and the needle doesn't move ( it has about 3/4 tank of gas). If I tap on the guage, the needle goes to full and stays there. The sending unit tests good, the wires test good, the guage tests good. Why won't it work???? It's probably something simple that I am missing, but I can't seem to figure out what it is. Any ideas??
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.