Posted by super99 on August 31, 2019 at 03:51:43 from (50.109.82.247):
In Reply to: MF 300 jam posted by Bruce7M on August 30, 2019 at 09:41:40:
Where the feeder house attaches to the combine there is a vertical panel just below the motor that should have 2 spring loaded pins on it. Take that panel off and you will see your problem. A 5 or 6' pry bar works good as anything to shove into the cylinder and try to turn cylinder as you dig it out. Wear a pair of leather glove so you don't cut your hands all up. As said, turn the cylinder backwards until the feeder house is cleaned out. You will also have to clean out under the auger on the header as you turn the cylinder backwards. Behind the grain tank on top of the machine there is a door that opens up. Check in there and make sure your straw walkers aren't plugged also. IF the straw walkers are plugged, start there first, otherwise when you turn the cylinder backwards, you are trying to jamb all that stuff back thru the cylinder. Most likely you had a large amount of crop bunch up in the head and then try to go thru all at once. When you get it all cleaned out, you will know to be more watchful for slugs at the header so you don't plug it up again. Usually the longer it is in there the harder it is to get it out. Chris
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.