Posted by David G on January 27, 2018 at 10:14:58 from (209.181.208.169):
The correct place for firing to occur is 10-20 degrees ATDC, variances in the flame front speed will cause the ignition event to be at a different BTDC time so the firing occurs in the range listed.
Pre ignition is caused by hot spots in the cylinder, no disputes.
There is a lot of talk about causes of detonation, and it is a vague term.
I stand by my statement that detonation is due to excess fuel, either due to over fueling or poor homogenization, as it is caused when the flame front hits excess unburned fuel. The speed of the flame front varies due to cylinder pressure, AFR and fuel quality. Flame front speed will increase with compression. Fuel and the oxygenation of said fuel varies the flame front speed. I am searching for the AFR effects on the flame speed and welcome discussion.
The sound of detonation and preignition are basically the same, but preignition causes more damage due to the push back on the piston as the crank is moving it up.
Here is a good article on the theory of combustion in a cylinder.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.