Posted by Farmall 656 on October 15, 2017 at 18:11:25 from (24.179.131.116):
Looking for some advice, thoughts, suggestions, etc....My dad has a Lester hog finishing building with a 8' pit, sitting empty for the past 10-12 years. Too small nowadays for the hog farmers around SE Minnesota. The east side slopes down below the pit level into a permanent pasture. A suggestion to us was to convert the finishing barn into a machine shed by digging out the middle section of the east pit wall that levels out to the pasture. Put in an overhead door and some new lights and have a new storage/machine shed. The building is 40x60, slatted floor, a foot or so of sludge at the bottom of the pit...so there is a bit of clean up and take the cement slats out of the floor, hot power wash the walls and floor of the pit, seal/paint the walls and floor of the pit, put in a new overhead door, and landscaping.
Has anyone tackled such a project? Suggestions? Best practices, tips, or tricks?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.