Posted by wilson ind on August 22, 2016 at 15:21:44 from (50.235.29.222):
Reading another post about a grade 8 bolt shearing got me to think about a problem I have. The machine is a rotary cuter six feet in cutting diameter.Brand is unknown, condition is old and well rusted. Cost was $75.00 five years ago. Use is cutting brush on and close to fence rows. Its 3 point mounted on modified DC Case with steel wheels to avoid tire problems. The underside has an approx two foot diameter metal hub for attaching 2 blades. The hub is splined , siding up onto a splined shaft protruding vertically from the gearbox. This 2 foot diameter splined wheel is held up with one 5/8 course thread bolt 3 inches long. From years of wear the hub splines and gearbox shaft splines are wore to the point there is wiggle when brought up tight. I have sheered 4 bolts dropping the large wheel with blades from the machine. I have drilled and removed both grade *8 bolts as well as grade five. I am wondering if grade 2 would be a better choice as the softer bolt might nor shear as quickly as harder bolts? Seems the bolts usually shear when hitting a mound of dirt or small tree of maybe 3 inch diameter. Possibly some company makes a bolt of spring steel lol Replacing either the gear box shaft or the wheel is not foreseeable in my cheap nature!! Any advice is requested I realize the explanation is long, however most request never totally state the problem.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.