Posted by 4020guy on March 23, 2015 at 20:35:20 from (68.171.72.108):
Neighbour decided to blow out his welder. Only didn't remove wires from the on/off switch before removing the cabinet and broke the old fibre backing on the switch. He removed the switch and didn't mark the wires going to the primary coil. Dumped it off here and I replaced the switch with a 50 amp breaker. Only thing is there are 3 wires leading from the coil, E1,E2,and E3. The Lincoln website only shows 2. On this one, E1 comes from one side of the coil, E3 comes from the other side of the coil and E2 comes from 1/4 inch in the coil near E3. I assume one hook up is for 240 volts and the other is for 208 volts. Hard to tell but looks like E1 and E3 were used and E2 was not. That would be the larger coil used with the 240 volts. Wouldn't the larger coil be used with the lower voltage and the smaller coil used with the higher voltage? Similar to ampere turns in motor winding? Just wondering? Thanks in advance......Ron
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.