Posted by todd hamilton on January 16, 2015 at 21:18:49 from (70.198.132.42):
In Reply to: I set the valves.... posted by BenH97 on January 16, 2015 at 18:02:21:
Some simple tests. Take the hood and valve cover off. Crank the engine over and watch the valve train for proper mechanical operation. If that looks right hold your hand over the air intake while somebody else cranks the motor. You should feel healthy pulses of suck. If you don't then valves are not properly set and there is no vacuum to pull the fuel through the carburetor. If this checks confirm proper timing and spark on #1 cylinder. Hold the spark plug grounding the nut of it to the engine and watch for spark when timing mark comes around tdc. If all this checks out shoot some wd40 in each cylinder and see it it pops off momentarily. If that is successful shoot some wd40 into the air intake on the carburetor while somebody cranks the engine. If it tries to run you are not getting fuel through the carb.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.