They make a tool to remove seals with a slide hammer. It's basically a sheet metal screw that you drill into the seal body and pull it out.
They also make a seal puller that is basically hooked on one end and has a spot on it to hold as well as hit with a hammer. To use it you put the small, hooked end through the seal opening and hit it with a hammer to pull the seal.
Something I have had to do on many occasions is to use a regular sheet metal screw to pull the seal. Basically get a hole started with an awl, or whatever you've got on hand, and screw the screw in through the hole. When it hits the housing no the back side it will typically push the seal out. Unfortunately there are seals in so tight that the hole will strip before the seal moves. In that case a combination of that, and what it sounds like you did to the seal you removed usually works.
Beyond that' I have never found one, certain tool, or way to get a seal out, and never a way to do it that leaves the seal reusable.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.