I have no idea what brand of baler that is, so this might not apply. On my New Holland 273 baler, the length of the "tail" on the knots could be determined by two things:
1. the "tongue" on the billhook holds the knot while the stripper pulls the knot over the ends of the twine and also pulls it off the billhook. The tension on the tongue is adjustable with a bolt/nut just to the right of the knotter frame where the billhook is located. I suppose that tension could be too low allowing the knot to slip back a bit before it is completed.
2. the stripper arm also holds the twine knife that cuts the new knot loose. I suppose that the knife could be too close to the billhook, thus resulting in a short piece of twine being available to form the knot.
New Holland has a tremendous youtube of a training movie that was made a long time ago to explain the operation of the knotter. If your baler has that style of knotter on it, it might be worth watching. Search New Holland knotter on youtube if you want to find it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.