Posted by GarrettFields on December 15, 2012 at 09:32:44 from (98.23.7.126):
Ive been off here for a while, couldnt use my old handle (KYGarrett) for some reason so I broke down and made a new account, with yet another password to forget. Any way I finally found and purchased some grain bins fairly close(180mi), and now I have to get them apart. Actual bin jacks are out of the question, so Dad and i were contemplating taking a road tractor tire up through the middle and lifting them like that so we can take it apart. I havent had any luck finding a boom truck to rent, but there are several rental places that have shooting boom fork lifts(telehandler). My concern about that is it will be very hard/impossible to get a straight lift. When i put them back together at my place i can use my excavator, but hiring it hauled that far is out the question. Would you guys attempt to do it with a telehandler or breakdown and rent a excavator? Also should one leave the door frame in or take it out at the start? I was planing on taking the ring right above the floor loose/out first then working my up until the roof is left? Any tips on the roof? Any thing special to know about the perforated floor and unload augers? As you can tell this will be our first time fooling with bins so any advice is greatly appreciated. There are 4 bins. Two are 12'hx14'w, the third is 12'hx15w, and the fourth is 14'hx15'w. Thanks in advance for the help!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.