Posted by John T on August 07, 2012 at 11:20:02 from (216.249.82.117):
In Reply to: ceramic resistor posted by mb58 on August 07, 2012 at 10:41:43:
If an ignition ballast resistor (between IGN output of ign switch and coils input) were open (infinity ohms), then there wouldnt be any voltage on its output even if 12 was present on its input as should be.
The ballast resistor should measure continuty from end to end of around 1.25 to 2 or so ohms.
If theres battery voltage on the resistors input (from IGN output on Ign switch) and the output is connected to the LV Primary of a coil and the coils other terminal is wired to the distributor and the points were closed and good and working, Id expect 12 volts on the resistors input but only 6 on its output i.e. a 6 volt voltage drop ACROSS IT. ASSUMING A 12 VOLT TRACTOR WITH 6 VOLT COIL AND A BALLAST AND ALLS CORRECT AND WORKING AND POINTS CLOSED
If the points were open Id expect 12 volts on the resistors input and likewise 12 on its output.
TAKE AN OHM METER AND MEASURE THE RESISTORS RESISTANCE!! It cant be an open circuit but should be around 1.2 to under 2 ohms or so typical.
If for some reason (wiring wrong or a short etc) the output of the ballast was connected to the tractors frame ground, Id expect 12 on its input but zero on the output i.e. its dropping the entire 12 volts across it
If its a regular series ignition circuit ballast resistor (between ign switch and coil) and bad/open that can prevent a spark but shouldnt stop starter motor from cranking????????????
Sure its an ignition balalst and sure all is wired correct???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.