Posted by The tractor vet on March 31, 2012 at 08:27:32 from (75.19.127.43):
In Reply to: cummins oil pr. posted by heavyhaulertoo on March 31, 2012 at 08:10:59:
Well it should not go below 40 PSI even at ideal with that few miles on it . Don't know who's oil your usen . myself i run Delo 400 15-40 and i hold 45 lbs. on my 95 , my buddy has a 01 and he is wright at 40 hot and he runs Case I H #1 15-40 . If you are dropping oil pressure like that i would (1) be looking into maybe fuel dilution due to leaking injectors , leaking fuel pump past the seal. (2) premature bearing failure , (3) bad senor (4) oil pump failure . And just how far do you have it cranked up , Ya start cranking them up you take away the life of the engine . Been seeing a lot of the young guys around here that have them wound tight with there five inch exhaust bigger charges and programmers maxed out keeping the guy down the street really busy with transmission repairs clutch jobs and engine rebuilds.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.