Tractor Memorabilia Discussion Board |
Re: John deere 12 a combine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan - Florida on January 03, 2004 at 09:34:02 from (205.188.209.106):
In Reply to: John deere 12 a combine posted by Ty O'Neal on January 02, 2004 at 14:12:34:
Ty, Since no one else has answered, I'll try to help. I don't have any information on the 12-A, but I do have a sales brochure on the No. 25, which replaced the 12-A, and the dimensions should be pretty close. Length, Over-All, with Tractor Hitch = 19 ft. 4 in. Width, Over-All, Cutting and Transporting = 10 ft. 2-5/8 in. The wheels set in a little bit from the outside edges of the combine, but I have no idea how much narrower they would be - sorry. I wondered how it could be the same width whether cutting or transporting, and then looked a a diagram of the two positions. The combine is the same width, no matter which - the only difference is in the tractor setting out farther to the right in the transport position. Height Over Clean Grain Elevator = 9 ft. 2 in. Weight = Approximately 3,400 lbs. You might want to post your question on the John Deere forum - I'm sure you'll get more answers over there. If you'll drop me an e-mail at StanHuff@aol.com I'll scan the diagram of the width displays and send it back to you. Again, this is a No. 25 combine, but if anything, it might be slightly wider than a 12-A but certainly no smaller. Good luck, Stan Huff Melbourne, FL
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|