Posted by rustyfarmall on November 08, 2014 at 09:02:49 from (208.126.186.41):
In Reply to: Coating gas tank posted by Dave Salway on November 07, 2014 at 02:39:18:
Just clean the sediment bowl, make sure the fine mesh screen is in place and clean, then fill the tank with E10. Run the tractor as you normally would, but clean out the sediment bowl on a dailey basis. Eventually the sediment bowl will need cleaning only on a weekly basis, and after that, it should need to be cleaned only when the tractor is serviced.
That is the exact procedure I used on my 1940 H AFTER removing the tank and doing my best to get all of the rust and other crud out of it. Couldn't get nearly all of it, so I just put it back on the tractor. 15 years later and it has never given me any trouble. That H is the one with the Woods belly mower. It gets used a LOT.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.