Farmall & IHC Tractors Discussion Board |
front rim slipping
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tony on January 04, 2001 at 15:07:20 from (156.144.109.28):
I just bought a new front tire and tube for my H. I remounted the one piece rim using the three clamps. I had a heck of a time getting those nuts tight enough! After plowing some snow I inspected the tire only to find my new valve stem cut by the clamps from the rim slipping around. Looking at the back side of the casting, there was too much clearance to keep the hex head bolts from turning while tightening up the nut. I figured that square head bolts must go there. But book shows hex head. I also searched the archives and others have had problems too. The only suggestion I could find was to use lock washers on casting side and rim side. Does anyone have any other suggestions for keeping the rim tight and in place? Thanks!
Follow Ups:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|