Posted by Haas on December 10, 2013 at 10:18:11 from (50.142.111.41):
Recently, I purchased a Woods L59 mower that had been left outside unused for several years. I was hoping that I could free up the spindles and all would be OK. However, that was not the case, as the mower is very noisy due to the bad spindle bearings. I decided to try and replace the bearings in the spindles rather than buy complete spindle assemblies as recommended by Woods. It appears from the parts diagram that the only thing holding the spindle shaft in the housing is a sleeve with a roll pin on the top side of the spindle. Looks like once the roll pin is out, the shaft should press out the bottom and then the shaft seals and bearings can be reomoved and replaced. However, not the case!! I have a shop press with a 20 ton jack. I've pressed some really tough things with it, but that shaft will not move at all. I'm afraid to put any more pressure on it. What am I missing??? Has woods pressed all this together with an industrial strength press or is there another retainer in there?? Of course there is some rust on the shaft collar, but rust has never kept me from pressing parts apart before.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.