Farmall & IHC Tractors Discussion Board |
Front axle pivot shaft Super A. Help!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by hendrik on December 09, 2000 at 14:52:21 from (62.100.7.206):
I'm trying to separate the front axle from the front casting of my '48 Super A. I removed the two bolts that clamp the shaft in the steering gear housing base and then easily hammered the pivot shaft (part number 351821R1) backwards approx. 1 inch; it just cleared the front clamp. Then it stopped as if it hit solid steel. I hammered it back again but the shaft hardly moved. It will not go backward or forward to some extent but I can easily rotate the shaft and move it about 1/16 inch. My theory is that the shaft has seized in one of the bushings in the front axle. What can I do to remove the shaft? Any help will be greatly appreciated! Thanks, Hendrik
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|