Posted by Janicholson on November 16, 2013 at 09:52:17 from (74.60.94.18):
In Reply to: another Cub question posted by charlie M on November 16, 2013 at 09:15:04:
Great question. If the tractor has been sitting for more than a year or so the valves may have pieces of rust or flakes of trash material under them. I would suggest that the engine should be pulled in a parking lot at 4-5 mph in road gear for at least 1/4 mile before condeming anything. Cubs often have difficulty building oil pressure after sitting due to the pump being in the block casting, and above the oil level. I would pressurize the oiling oiling system with a pump oil can, and a small rubber hose to connect it into the oil gallery at the filter housing (1/8" pipe plug, probably hex key) If it shows oil pressure all is well. After pulling it then check the pressure, if as bad then, it will need to have the head pulled off, and looked at for possible burnt valves and bblown head gasket. The rings may be stuck causing the 50# numbers. If the Zero psi cylinder comes back to 50 or above, I would get it started before tearing it down. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.