Farmall & IHC Tractors Discussion Board |
This Dist. Has Steped On My Last Nerve
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Merlin on November 28, 2000 at 10:55:36 from (209.205.162.187):
Trying to start the Super AV I acquired earlier this week. I put an alternator and 12 volt battery in it. It has a 6 volt coil. So I put an inline resistor in it. With the switch on, it is 12 volt on one side of the resistor and 6 volt on the other side. I put new points, rotor button, condenser, cap, wires and plugs. Set the points at .020 and the plugs at .025. Well, it gets fire to the points, but won't go any further. Using a test light, when the points are open and I put the test light on the points, it lights up. Points closed it don't. With the points closed and you take a small screwdriver and gently open them, usually a small spark can be seen (and/or heard) between the point contacts. Nothing here. I have checked a dozen times to see if it is grounded somewhere, but can't find anything. Any ideas guys? Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|