I have to agree with that. You can never get the valves really set hot with a standard feeler gauge. The temperature drops considerably between adjusting the first valve and the last. I prefer motors that give a cold setting. All clearances are set at equal temperature and there is no chance of burning your hands or arms on hot engine parts. We set the valves on the Farmall H a couple of weeks ago. Very easy with magneto ignition.
1). Remove the high tension lead from the magneto cover to the centre of the distributor cap.
2). Get the motor to top dead centre on Number 1 cylinder.
3). Set valves on Number 1.
4). Turn motor 180 degrees (until impulse coupling trips). Set valves on Number 3.
5). Continue the same through 180 degrees for Number 4 and Number 2.
Then check and reset them all again as necessary, having turned the motor over several times. This ensures a much better setting than just going through once.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.