Posted by CoopertownBob on May 14, 2012 at 23:51:54 from (74.51.5.84):
In Reply to: ? Pete 23 or anyone posted by Mike1972chev on May 14, 2012 at 18:14:46:
With the adjustable load screws, bigger jets were not necessary with the big bore kits, just turn the screw out a little more. I am assuming you have either the 358-065-R91 gas or the 363-741-R93 dist/kero carb? If you already have it, go back to the stock size, or, if you are going to have to buy it, get one for the 361-525-R92 gas carb. It is a .048 size jet, and will more than make up for any bore increase you have, and you'll get much better specific fuel consumption numbers from your tractor with it. You might want to check the venturi to see if it has been changed out for a larger, non-stock one as well.
As an interesting side note, the old one inch gas carb on the regular H had a .050 jet size in it from the factory and a 24/32 inch venturi, but the Super H's came with the bigger carb but with a smaller, 23/32 inch venturi size and smaller jet size.
This post was edited by CoopertownBob at 23:54:09 05/14/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.