Farmall & IHC Tractors Discussion Board |
Stuck 450
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Raider on September 13, 2000 at 17:21:46 from (208.188.19.122):
In preparation to really get things moving forward to freeing the gas 450, I pulled the head and took a look at things. It's a shame that water got in through the muffler because the head and valves are in excellent shape, not a spot of rust, wear or significant carbon. Even the cylinders had very little wear. #4 is clean, but 1, 2, and 3 are rough. It's been soaking in ATF, MM, and WD40 for 12 months. I pounded with a 2x4 and a 3lb. hammer for a few good shots. And now I think it is time for serious measures. If soda pop is used, how long should I leave it in? If the carbonation (carbolic acid?) works on the rust, would weakened naval jelly be better? My hope is to pull the pistons, replace the rings, then just hone the cylinders. Oil pressure was good before it sat.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|