Farmall & IHC Tractors Discussion Board |
Splitting A Cub; Any Advice?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george on September 04, 2000 at 17:34:20 from (172.134.194.28):
The clutch was acting up today while I was mowing with my '58 Cub. When I would engage, it would chatter. After I finished mowing, I opened the hand hole in the botom and it was full of clutch facing debris. Obviously a good portion of the clutch facing had self-destructed on me. I put the tractor in the top of the barn and proceeded to dismember it in preparation for splitting. I blocked it up and split it, but I think I'll need an engine hoist to assist with rolling the front end away from the rear to service the clutch. A couple of questions: 1. Do I need the clutch service tool to dissassemble the clutch or is there another alternative? 2. Would I be better taking the clutch assembly to an IH service shop to have it re-faced? 3. The throw-out bearing appears to be shot. Is this supposed to look like a typical bearing? Does it support the shaft securely? 4. Are there any tips/secrets for putting the tractor back together? Thanks for any assistance.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|