FWIW, on my Regular, I had zero compression on the guage, and could just feel a slight puff with my thumb on the plug holes. Pulled the head and the valves were toast. Fortunately, the seats weren't too bad. Picked up some good used valves, put a fresh face on the, and just did the seats today. Will lapp them tomorrow, and will probably put the head back on this coming weekend.
I fully expect to have good compression when I do. There was barely a ridge on the sleeves, and they look to me like the old girl got new pistons and sleeves at one point in her life, and not run much after that. Takes a day for 1/4 - 1/2 cup of PB blaster to leak down through the rings. IF I have the head off an engine, I like to pour PB blaster in and soak into the rings while working on the head. I even do that if all I am doing is replacing the head gasket . Doesn't hurt these old girls to loosen up the rings if they have been sitting awhile.
This post was edited by Tom Fleming at 01:51:26 09/12/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.