Posted by WD9ER on July 13, 2011 at 10:54:14 from (65.127.84.74):
Hey Dave,
Tractor looks good! I am in the process of starting a repaint on my WD-9. I have a couple of questions for you on how you sandblasted the tractor. Did you have any specific areas that you needed to be cautious about during sandblasting? I am concerned about sand infiltrating the transmission/engine and am wondering if there were any precautions that you took to avoid issues.
[quote="dave eklund"](quoted from post at 16:41:17 06/14/11) We got this tractor about 2 months ago been sitting for about 10 to 15 years in a garage in peices got it home checked it out got it to start and drove it up and down the driveway a bit found radiator was junk and switch in manifold for mag was stuck cleaned the gas and diesel tanks out new fuel filters and the the teardown here a few pics of the job hope to have it done for a show in less than 2weeks in Orange Ma. The red paint was sprayed 1st coat yesterday after work and 2nd coat this afternoon after work
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.