Posted by John T on May 17, 2011 at 10:36:31 from (173.243.189.183):
In Reply to: 706G fuel gauge posted by MattSillinois on May 17, 2011 at 08:25:35:
Not sure but if its like most older standard gauges temporarily ground out the wire that goes from the gauge to the sender in the tank and if that causes the gauge needle to full deflect THEN THE SENDER IS THE PROBLEM ORRR the wires open from gauge to sender ORRR the tank or sender isnt well grounded. Use a jumper wire to insure the sender has a good ground, some get their ground from the tanks sheet metal and it may not be well grounded, others may have their own ground wire.
If when you ground the senders little terminal where the wire down from gauge is attached the gauge full deflects, the gauge (and its input voltage) and wiring are both okay, so its either the sender is bad or theres a bad ground.
Also insure when the tractor is switched on theres hot batetry voltage getting to the input (NOT to sender) side of the gauge as it cant work unless voltage is applied to its input.
Finally if theres voltage on the gauges input and when you ground the output (just momentarily touch to it dont hold it on a long time) the needle dont move, its a gauge problem.
Often Ive seen gauges where the needle is just mechanically corroded and stuck.
For a gauge to be good there needs to be continuity from its input to output, if it reads an open circuit its bad.
Get it????????? If I missed anything or those gauges are differnt then I described, Im sure the other fine gents can add to this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.