Posted by Faster346 on April 11, 2011 at 20:51:13 from (72.241.201.224):
Hey guys, I put a New Idea Horn Draulic loader on my M today. It was said to work fine, but it's been sitting out back for years. Anyways, I hooked it up today. It all went pretty smooth, except for it wont raise more than about half way. I pull the rod and it takes about 10-15 seconds, then the loader starts to raise, and stops about half way up and wont go any further, which isn't going to be any good for me if I can't dump a load into the spreader. The lines are plummed from each cylinder into a T fitting, that goes to my remote hookup which is plummed into the passenger side front fitting coming out of the Lift All. The dipstick reads FULL and the fluid is SAE ND 30W. So I'd like to find out if this is an issue with my tractors hydraulic system (never had anything hydraulic operated on it before) the loader itself, or my plumming. Thanks!
Couple pictures. Video wont load, so I'll try to rehost it and edit it in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.