Posted by Tom in Iowa City on February 27, 2011 at 06:01:22 from (173.30.220.194):
I have learned quite a bit. Problem, again, is to try to get a tighter fit between the spline shaft of the transmission and the transmission joint (hub) due to excessive wear.
Here is what I have learned: 1. Probably no problem to run the tractor AS IS and except the wear. I will be running it quite little, although I want to take it to a show once in a while, run it a little around my shop from time to time.
2. To fix it: a. Welding, milling and re hardening. Concerns with welding: A. getting a hard enough welding rod. B. softening of the shaft due to heat incurred with welding. C. need or no need to re harden the shaft.
A local shop estimated it would cost about 600 dollars to do this. A little rich for my blood.
A neighbor offered to TIG weld one spline at a time and then I use my sweat equity to grind to fit. Then we do a spline opposite to that one, again I regrind.
Question: would this weld be hard enough to be adequate? (It would be normal TIG weld, if there is a normal hardness with TIG weld.)
Question: would this soften the shaft enough that I would have to reharden it?
Could I take the welded, ground rod to a shop to have them re harden it? I understand re hardening might entail heating to say 1500 and then quenching and then heating to say 750 and quenching to draw it.
I have had a neighbor 30 miles away offer to help also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.