Posted by Owen Aaland on July 26, 2010 at 14:05:55 from (207.13.114.172):
In Reply to: fuel in oil 706D posted by Michael Johns on July 26, 2010 at 08:10:02:
The weight of the fuel in the tank will exert less pressure on the pump housing than a return line that enters the top of the tank. The pressure is determined by the height of the fuel level above the pump. The amount of surface area of the fuel in the tank will not affect the pressure in the line. A fuel return line going to the top of the tank will always be filled to the uppermost part of the line. A fuel line returning to the bottom of the tank will have a pressure dependent on the level of fuel in the tank. A check valve in the lower tank fitting can increase the running pressure of the pump.
The pump should be sealed to hold the pressure the charge pump develops, somewhere around 60 PSI. I would look for wear in the pilot tube where the seals ride. If the tube has been replaced and not installed with the correct sealant it is possible that the fuel can leak between the pilot tube and pump housing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.