Posted by Trapman on September 07, 2009 at 19:50:38 from (69.89.205.141):
I was out to my dad's in North Dakota and put in a 12 volt conversion kit on his 52 super M and along with doing this I set the valves,made sure the points were correct and it starts nice and it seems to run smooth ( I guess when I say that the valve train sounds smooth) but the tractor kind of gallops at an idle like it is getting a little to much gas at times if that makes any sense. Another thing is when you pull on the throttle to increase the rpm's you have to pull from an idle to 3/4 throttle before any changes at all happen to the rpm's. He had the carb off early this summer and cleaned it out because it had sat for 4 years. I guess my question or questions are where should I start? Am I wrong thinking this is a fuel/governor problem? Can i make any adjustment with the governor? I ran out of time to go any further with it but i did lube the linkage points on the throttle assembly etc. Any help would be appreciated. Thank You
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.