Posted by charles todd on January 01, 2009 at 16:34:50 from (205.242.95.141):
In Reply to: OT Drilling Concrete posted by GordoSD on January 01, 2009 at 07:19:22:
I read the first post but was unsure if you are using a conventional drill or a hammer drill. Concrete bits are only designed to work in a hammer drill. They will last a long time if used properly in a hammer drill. A conventional drill will burn the bit up shortly regardless of speed due to constant friction. The hammer action breaks up the concrete as it drill. There are Masonary bits that are for convetional drills for drilling block, brick, or morter only! Try to drill cured concrete with a masonary bit and likley it will dull before the hole is finished. Star drills are still available but why? They are slow and well, slow. Find a friend that has a hammer drill before you decide to star bit. I have drilled A LOT of holes in concrete. A true hammer drill bit used in a hammer drill should last 50 + holes through concrete, wire, rebar, aggergrate, ect.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.