Hi, I have no experience on a 424 but lots of experience on the BD154 engine in the 424 as same engine was used in B414,434,444,384. Normally there would be a lift/priming pump on the right side of the engine but in the 424 setup the fuel system is completely gravity fed. I suggest to get fuel to come out of the top bleed screw put some air pressure in the fuel tank by placing a clean cloth around a compressed air gun and place it in the fuel filler hole and put a couple shots of compressed air in the tank this will force the fuel through the system and with the bleed screws open, let fuel flow until air bubbles stop, then close bottom bleed screw then top. Loosen a couple of injector lines at the back of the injection pump, throttle about 3/4, glow plugs heated and crank engine, DON'T CRANK ENGINE FOR MORE THAN a minute at a time or the starter will over heat.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.