Posted by dbanjo0335 on October 06, 2008 at 07:04:54 from (98.105.4.97):
I recently received a Farmall A from my Grandfather"s estate. It has previously been switched to 12 volt and has worked just fine in recent years. However, when I came to own this tractor, I found that I had to jump start it each time I wish to use it. I had the alternator tested and it works just fine.
Not knowing what else to do, I found an article about converting from 6 to 12 volt here on ytmag.com. Here"s the link:
http://www.ytmag.com/articles/artint195.htm
I figured that I could follow the instructions and included wiring diagram and rewire the whole charging system - which I did. When I finished, I went back over everything twice to make sure I had done everything correctly.
But, when I hooked the jumper cables up, the wires coming from the switch began to smoke heavily. Before I could remove the cables, the wires from the switch had melted between the switch and the ammeter as well as between the switch and the warning light/ignition coil.
I have gone back over everything I did and I am confused. How can I correct this problem?
Also, my tractor has the ammeter in a box just forward of the shifter. Below the ammeter in this box is a knob. I assume this knob controls the lights, etc.??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.