Posted by ScottyHOMEy on September 29, 2008 at 02:50:07 from (70.105.248.74):
In Reply to: Super A belt pulley posted by Jay Poole on September 29, 2008 at 02:33:39:
Are you talking about the actual belt pulley or a pulley mounted to the PTO shaft to drive the mower? You'll want to have that terminology correct if you go to order new seals, just in case they might be different for each application. (The belt pulley is oriented perpendicular to the long axis of the tractor, and the PTO is parallel to that axis.)
In either case, your parts book will show a single seal on either shaft. The new reality is that the shells of the seals now available are not as deep as the originals, and it is quite common to put two seals on those shafts, one over the other. This is sometimes also and effective cure for a spot in the shaft that might have been worn down far enough that a new seal on that same spot would still leak. If in using two seals you are able to get the seal surfaces on different, unworn spots on the shaft, you should get a good seal. Some folks go so far as to pack grease between the two seals. That might be overkill if you've got a good surface on the shaft to seal to, but falls into the "can't hurt, might help" category in my view.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.