Posted by Chris NW Ind on May 03, 2008 at 14:40:21 from (64.136.26.226):
I'm trying to remove the clutch shaft to replace the clutch release parts. Stage II Super M. (Either bearing carrier or drive shaft yoke got loose and tore up the carrier and sleeve, and maybe bent the shaft.) Every manual says it is possible to remove the shaft without splitting the tractor.
Well, I"ve tried everything I can think of: loosened the PP assembly, tried pulling the input shaft flange off (can"t pull it far enough forward), loosened up the front bearing assembly. I cannot find the clearance to pull the shaft out.
Anyway, Ive pretty much decided that I"ll have to split but I thought I"d run by you guys to see if there are any suggestions for me.
If nothing else, it"ll be good practice for a 560 split I have coming up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.