Greg-N-CA said: (quoted from post at 05:24:39 04/15/08) Pete,
I would not try using all thread in the end of the crank. The amount of pressure it took to install the pulley would pull the all thread right out of the crank! I oversized the holes to make it (more or less)centered to push on the pulley.
I used a plate from a seal driving tool (large truck) against the pulley to push with, that's probably what your seeing as a second groove. My pulley only drives a single belt.
I heated mine up, as did Hugh, warm to the touch. I highly recommed using 2" square (at least 3/16 wall) to make the tool with. I tried making one with 1" square and it crushed about half way on. By the time I made a second one with 2" square, everything cooled down.
1. Nice pulley installer... I would hate to see what it took to remove it.
2. Nice paint job on the touch control unit. What brand/color of paint are you using? What reducer and hardener? Is it fairly easy to work with?
3. Keep up the work on the SA, and post some more pics.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.