Farmall & IHC Tractors Discussion Board |
Another 400 question
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Richie on February 28, 2000 at 10:57:21 from (209.64.118.230):
Fellows As most of you know I bought that 400 with an F-10 farmhand loader on it. The trouble is that the drawbar comes out and ends right under the lower rear framework of the loader. To my knowledge there is no way to extend the drawbar like later model farmall's. Only one hole in the drawbar to put the pin under the belly in. The back of the drawbar is connected to a flat steel that goes between the two point fast hitch. I want to be able to use this tractor to run the feedwagon so I can quit starting two tractors every morning. Is there another drawbar option that I guy can buy to extend the drawbar out past the underneath of the rear of the loader? The steel on the rear framework of the loader is not heavy enough to weld a "tongue" to and hook the feedwagon there. Am I done for? I would make a new as well but there's a tremendous factory bend in the drawbar where it comes up from underneath the belly and I don't think I'm talented enough to put one in there on that hard of steel without taking the temper right out of it. Any Suggestions? Thanks Rich
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|