Posted by the Unforgiven on November 28, 2007 at 10:48:43 from (66.146.249.116):
In Reply to: Is it worth it posted by old on November 28, 2007 at 09:35:41:
If it is on good round spokes and the tractor is fairly straight it probably is not too bad. If is is on cut-offs or if the rims are crap I'd say about $300 too. Shutters, pto extension, and original throttle and mag linkages help too. The best way to pay too much for an otherwise "good" one is if the main bearings are crap, look in the side covers and see if there is ANY sign of rust on the mains. If they get bad it will sound like about twenty bowling balls rolling down a sidewalk, the mains are expensive and a lot of horsing around to change. They are awful tough to wear out but rust will make them noisy quick. Good 20's usually bring a little more than a 12 or 14, and about 1/3 or 1/2 of a 30. Narrow Treads are a much nicer tractor too, they will have an N at the end of the serial number, just in case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.