Posted by John T on September 20, 2007 at 18:14:29 from (66.244.83.147):
In Reply to: cutout vs VR posted by flashback on September 20, 2007 at 13:51:55:
Id be glad to use the VR instead of the old cutout cuz it automatically sets the correct charge rate as opposed to you manually using Low or High Charge on the light switch.
On the old cutour relay the gennys Field post wired to the light switch but you no longer use that connection with a VR, it wires as follows if its a 3 terminal (BAT ARM FLD)
BAT on VR to ammeters Load terminal, thats the same wire that used to wire to BAT on the relay
FLD on VR to gennys Field post instead of up to the light switch with a relay.
ARM on VR to gennys ARM post
If its a 4 terminal VR with the extra 4th L terminal, that terminal now feeds hot battery voltage to lights n ignition instead of them being fed off the ammeters load terminal as with only a relay or a 3 terminal VR
If its a 3 brush genny Id set it for max charge rate. Polarize the genny prior to start up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.