Farmall & IHC Tractors Discussion Board |
Farmall B alternator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave H (MI) on August 04, 2007 at 07:50:39 from (64.12.117.137):
Good Morning! Kinda pretty one here in SE Michigan but me thinks the heat will be back in an hour or two. I soldered up my wire last night using the 3 amp diode from Radio Shack. I found the part Rich recommended but it is a long way into town and I was unsure so I went with the known quantity. I am not a fan of soldering on #10 wire especially when my larger solder tips are AWOL but I got it done. Installed it this morning, propped the ammeter where I could see it and hit the switch. Immediately noticed the static discharge reading on the meter...hopes soared. Pulled the starter and she fired to life. Meter jumped all the way to the right (20) and then settled down gradually to around "5". This alarmed me because I thought it would be close to 14 but then I remembered that "around 14" was the reading at the battery with the VOM meter if the alternator was charging. When I checked that reading it was indeed about 14 volts. Tractor is running currently and it is too soon to tell if it will run better but it seems to be. This sounds like a positive result to me! Appreciate the massive effort you guys put in helping me. Now if anyone has an easy way to get a #10 AND the coil hot wire onto a quarter inch spade connection at the new switch I would love to hear it. I hates these big stiff wires! Would like to avoid that carburetor if at all possible and move on to the 2N now! Had the battery for it on charge all night but she is not taking it.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|