Farmall & IHC Tractors Discussion Board |
Re: Removng International 454 Final Drive
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave in Southern IL on July 23, 2007 at 15:06:44 from (216.138.60.195):
In Reply to: Removng International 454 Final Drive posted by Bob Patrick on July 23, 2007 at 13:01:58:
I am not familiar with the 454 but I recently replaced a brake seal on my 424 and in order to accomplish that you must drain and remove the hydraulic housing, drain the differential housing and remove the bull gear which is attached to the end of the drive axle by either a bolt or a snap ring. It is not a hard job but messy and time consuming. I think that the two tractors are similar enough that you would have to follow the same procedure as I did.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|