Farmall & IHC Tractors Discussion Board |
Re: Cylinder Sleeves
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by sentry on February 14, 2007 at 13:51:00 from (66.67.22.144):
In Reply to: Cylinder Sleeves posted by Dave From Texas on February 14, 2007 at 10:31:58:
Dave, There are many methods to remove piston sleeves (liners). I have always had great success by utilizing a sleeve puller. This method is the safe way , it causes no damage to the block if properly performed. Sometimes they can be stuck in pretty bad. Heat can be used to persuade them but sparingly. As far as performing this without removing the block.. Yes, it can be done. Although to prepare the block for new sleeves it is best to remove the block, thoroughly inspect and clean the mating surfaces. An engine stand will help you there as you will be able to position the block for ease of work. El Toro and Janicholson have also provided you with some very valuable advice. If you have never done this before find a friend with some experience and take it slow. Remember it all has to go back together. Good luck with the restoration…
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|