Farmall & IHC Tractors Discussion Board |
Re: Cub rod knock, oiling problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on January 23, 2007 at 04:08:38 from (152.163.100.65):
In Reply to: Cub rod knock, oiling problem posted by Steve Sawyer on January 22, 2007 at 21:34:49:
I think that is quite common on the Cubs on losing their prime on the oil pump. I would buy a new oil pressure gauge and I would plasti-gage all those bearings for clearance. Check those cylinders for wear too. There's an allen head plug at the left side of the block and you can squirt oil in here and remove the oil filter cap and fill the housing with oil and replace cap. All the Farmall tractors have their oil pump bolted directly under the engine and is submerged in oil and as are most American cars and truck engines. The Cub pump is mounted at the rear of the block and that could be a design problem. I would pay close attention to the oil pressure gauge when starting the engine. I think this has happened when changing oil too. Hal
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|