Farmall & IHC Tractors Discussion Board |
Voltage Regulator... the saga continues.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Williams on October 10, 2006 at 18:17:58 from (24.113.128.168):
So I got it hooked up just as everyone said. It just so happens that it is the same way it was hooked up back when it was working before I had the short that melted the wires on the battery terminal on the voltage regulator. Since then I have replaced the wires, checked the inside of the VR, looks good. Polarized the VR and replaced the ignition switch. When I turn the key in the ignition it doesn"t do anything. With the key on the VR has 6 volts to all three terminals. It won"t turn over unless I ground the pole that goes to the solenoid on the starter. When I do that it turns over but I don"t get any spark to the plugs. Is there some way to test the VR and the Generator without taking them in? It has to be one of those components, I guess? I would think that the VR is bad as it had the wires on the BAT terminal fried, I don"t see any obvious signs of mechanical failure in it though. Where would you get one of these most affordably? Thanks again for your help! I have a 53 IH 300 U.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|