Farmall & IHC Tractors Discussion Board |
Re: Farmall H Creeper gear?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on October 06, 2006 at 11:36:27 from (4.154.243.54):
In Reply to: Re: Farmall H Creeper gear? posted by Bob M on October 06, 2006 at 09:21:38:
Standard first gear reduction is 19/44=2.31 Low,low first gear reduction is (I believe) 14/49=3.50. I need to qualify those numbers. These numbers are for a M. My H book is on loan. Secondly, my parts book does not specify the number of teeth on the low-low countershaft with its integral first gear. I am assuming the total number of teeth on the main shaft and countershaft has to remain constant when added up as a gear set. Consequently, after doing the math, a low-low set will have 66% of the speed of the regular set. That would be similar to a TA. In fact, you cannot buy , out of the parts book, a low-low set for a TA equipped tractor. However, SMTA and 400-450, can use the 560 gear set and wind up with a farmer-engineered low-low. I doubt if the factory would bless or a dealer would do such a modification. There is alot of wheel torque when such a modification is used with the TA.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|